top of page

IRS Rules for Long-Term Construction Contracts: Percentage of Completion, Exemptions, and the 2025 Residential Change

Writer: Cost Construction Accounting
Cost Construction Accounting
8 minutes ago
5 min read

By Tammy Hoang, QuickBooks ProAdvisor — Construction Bookkeeping Specialist | Construction Cost Accounting

Direct answer: for federal tax, long-term contracts generally have to be reported under the percentage of completion method, which means income is reported as the work is performed and not at the end of the job. Section 460 of the Internal Revenue Code sets this rule, with exceptions for home construction contracts, small contractors, and, for contracts entered into in tax years beginning after July 4, 2025, residential construction contracts. A contractor's CPA decides which rules apply to each contract.

This guide covers the Section 460 requirement, the exceptions as IRS and CPA sources describe them, what the 2025 law changed, and the job costing records that support any method. It is general information, not tax advice. It builds on CCA's look-back method guide and tax planning guide.

1. What Section 460 Requires?

The IRS Construction Industry Audit Techniques Guide says Section 460(f)(1) "generally defines a long-term contract as one that is not complete at the end of the tax year," and that under Section 460(b)(1) taxpayers "must use the percentage of completion method to report taxable income" from these contracts. It describes the cost-to-cost measure as comparing "the total allocated contract costs incurred to date with the total estimated contract costs." Source: IRS, Construction Industry Audit Techniques Guide. The guide is dated May 2009 and states it is not an official pronouncement of the law, so it is cited here for the definitions only, and current rules should be confirmed with a CPA.

That definition is why job costing matters for tax, and why careful job cost bookkeeping matters before any return is prepared: the cost-to-cost percentage needs every cost to be recorded to the right job and an up-to-date estimate of total contract cost. CCA's job costing guide covers the cost side.

2. Which Contracts Are Exempt?

Section 460 does not apply to every contract. The IRS Instructions for Form 8697 list the contracts excluded from the look-back method, including home construction contracts and "any other construction contract entered into by a taxpayer" who estimates the contract will be completed within a set period and meets a gross receipts test. Source: IRS, Instructions for Form 8697. Three categories matter for contractors:

  • Home construction contracts. These are exempt from the percentage of completion requirement.

  • Small contractors. The exception turns on the estimated length of the contract and the contractor's average annual gross receipts for the three preceding tax years. The IRS audit guide describes this test. The completion period and the dollar limit have changed over time, and Forvis Mazars states the receipts limit is adjusted for inflation, so confirm the current figures with a CPA. Source: Forvis Mazars.

  • Residential construction contracts. For contracts entered into in tax years beginning after July 4, 2025, the exception was extended to all residential construction contracts. The IRS says the 2025 law extended the home construction contract exception from the percentage of completion requirement to all residential construction contracts, and quotes the definition as "any contract that would be a home construction contract but for the limit on the number of dwelling units in a building."

Source: IRS Revenue Procedure 2026-32. Schneider Downs adds the cost test: 80% or more of the total estimated costs must be reasonably expected to be attributable to building or improving dwelling units. Source: Schneider Downs.

Contracts that fit none of these categories remain under the percentage of completion method. Forvis Mazars also notes that contractors using an exception may still have alternative minimum tax considerations, while Schneider Downs reports that the AMT adjustment is no longer required for residential construction contracts. Because the two sources differ on AMT, that point is one to raise with a CPA.

Are your job cost records ready for your CPA?

Construction Cost Accounting helps contractors keep job costs and WIP reporting organized.

constructioncostaccounting.com  |  (949) 889-3283  

3. The 2025 Change and the 2026 Method-Change Procedure

In the IRS's Revenue Procedure 2026-32, the changes apply to contracts entered into in tax years beginning after July 4, 2025. The procedure describes two automatic accounting method changes for such contracts. Change 275 covers a move from percentage of completion to an exempt contract method, such as the completed contract method, and change 236 covers stopping Section 263A cost capitalization for residential contracts that meet the stated requirements. The procedure says the changes are made on a cut-off basis, with no Section 481(a) adjustment permitted or required, and that the modified sections apply to a Form 3115 filed after September 4, 2026. Source: IRS Revenue Procedure 2026-32.

Whether to change a method, and when, is a tax decision for the contractor and a CPA. The bookkeeping role in construction accounting is to make sure the job-level numbers behind either method, including the completed contract method, are complete.

4. How the Methods Differ in Timing

Assume a $3,000,000 contract, to compare percentage of completion with the completed contract method, with $2,400,000 of estimated cost, spanning two tax years, with $960,000 of cost incurred in year 1. The figures are illustrative arithmetic, not CCA client data and not tax advice.

 

Year 1 profit

Year 2 profit

Total profit

Percentage of completion (40% complete in year 1)

$240,000

$360,000

$600,000

Completed contract method

$0

$600,000

$600,000

Year 1: $960,000 ÷ $2,400,000 = 40%, so revenue is 40% × $3,000,000 = $1,200,000 and profit is $1,200,000 − $960,000 = $240,000. Year 2 adds the remaining $1,800,000 of revenue less $1,440,000 of cost, or $360,000. Both the percentage of completion method and the completed contract method reach the same $600,000, but they report it in different years. When the method is not a free choice, the percentage of completion column is the one a contractor must be able to produce, and it comes entirely from job cost records.

5. The Records Behind Any Method

In construction accounting, a construction bookkeeper should keep, for every contract, whatever the method:

  • The contract date, the contract price, and the estimated completion date

  • Every cost coded to the job, so costs incurred to date are complete

  • The estimated total cost, with the date it was last reviewed

  • Change orders recorded with both the added price and the added estimated cost

  • A WIP schedule showing percent complete and billings by job

Where Construction Cost Accounting Fits In

Your CPA decides the tax method and files the return. Construction Cost Accounting provides construction bookkeeping services for contractors, so the job cost records behind that decision are complete. Our construction bookkeeping services cover:

  • Job Costing set up by project, with every cost coded to the job

  • A WIP Analysis Financial Report built from your job cost records

  • Accounts Receivable and Accounts Payable handled by job

  • QuickBooks Accounting in QuickBooks Online or Desktop, kept current for every job

  • A construction bookkeeper who keeps your job cost bookkeeping organized

Learn more about our construction bookkeeping service, or visit www.constructioncostaccounting.com.

Section 460 generally requires percentage of completion for long-term contracts, with exceptions for home construction contracts, small contractors, and residential construction contracts entered into in tax years beginning after July 4, 2025. In the example, both methods produced $600,000 of profit, but percentage of completion reported $240,000 of it in year 1. Whichever rule applies, the numbers come from job costing and job cost bookkeeping, and a CPA confirms the method. A construction bookkeeper keeps that construction accounting record clean, and Construction Cost Accounting provides these construction bookkeeping services at www.constructioncostaccounting.com.

Talk with a construction bookkeeper today

Set up job costing and WIP reporting with Construction Cost Accounting.

constructioncostaccounting.com  |  (949) 889-3283  


Comments


bottom of page